Installing your new kitchen sinks can be tricky, especially if you need to enlarge or reframe your counter tops to fit. Many people find it helpful to have a guide to installing this appliance before they begin, so that they will know what they need to pick up from the hardware store and what kind of basins they should use.
Measure Your Space
Once you have removed your old kitchen sinks, take the time to properly measure the space that you have to work with. Many times, you can find basins that are made for home use are sold in one basic size, but there are also special appliances that are made in different sizes and shapes. This is an especially important step if you are looking for basics in unusual shapes or sizes, or if you need to enlarge the counter area in your home.
If you need to install larger kitchen sinks in your home, then you can measure the area of the preexisting sink hole in the countertop, and the take some additional measurements to determine how much of the counter space you can devote to the washing area. Once you have your measurements, you are ready to look at the pipes under the sink area.
Determine Pipe Sizes
The pipes under your kitchen sink are also important. You should notice the size of the largest pipe that runs from the bottom of the basins through the floor, and whether or not there are any sleeves or smaller pipes connected to the basin. You will need to have the pipe that runs through the floor connected to the basins that you install, and measuring these before you buy your new appliance will help you know what you need to install the new appliance in your home properly.
Make a List
To install your new kitchen sink , you will need to have several different tools and materials on hand. For example, you will need to have the proper pipes and fittings, along with glue for the pipes and a hammer to install your new appliance. Making a list and gathering the materials you have on hand will give you a good idea of what you need to bring home from the hardware store.
Mark It Out
If you are installing your new kitchen sinks into a new countertop, you will want to carefully mark your basin out on the counter before you began cutting. You can do this by laying the basin, upside down, on the counter top and carefully tracing the area with a pencil. Then, when you begin cutting, you will be able to match the area of the basins perfectly.
Use a Sealant
Lastly, remember to use a sealant around the area of your new kitchen sinks so that water does not leak though and damage your cabinet space below the appliance. This may seem like an obvious step, but if you forget the sealant, then you will have to redo all of the piping under the basins after you take it out again to seal.