Originally developed to imitate a vintage look (as seen on classic violins and mandolins), sunburst really is a timeless guitar finish regularly seen upon electric guitars classic and cutting edge. It’s an extremely desirable look but is it too difficult for the inexperienced? You’ll be able to achieve a sunburst finish for your guitar if you decide to stick to just a few steps and take your time and don’t rush. It’s good to practice to start with a discarded scrap piece of timber prior to moving on to the electric guitar.
If it’s a brand new guitar kit, you really should construct your guitar before anything else. As expected you will be pulling it apart to begin the finish but you need to know you won’t be finding problems further along that risk the finish you’ve obviously put such a lot of effort into. When you’ve put together the electric guitar and analyzed for potential issues you should begin to set up the timber. Sand back until you get an entirely even base to apply your finish. At that point remove excess dust particles and clean the guitar meticulously.
The next step is to smear some wood grain filler. You’ll want to apply evenly across the face belonging to the electric guitar and afterward work it in to the grain. Once dried remove the excess and wipe off with a moistened scrap of material. Now it’s the time to apply paint to the back and sides of the body and neck of your electric guitar. A crucial factor to remember is to always mask the body and neck area. If you end up spraying it’s recommended that you keep your aerosols in warm water before you start using. It will take you a number of coats to get a decent coverage. The trick is to accumulate your guitar’s colour layer after layer and apply from a good distance away in order to attain a gentle edge. The nearer you end up getting the more challenging the edge line you will end up with.
After that apply the amber lacquer. You should mask the sides of your guitar after which you’ll place the guitar on a dependable workbench faced upwards before you apply the lacquer. Once you have finished this task you should apply the clear coat and then sand between coats to remove any issues. Then apply your next darkest stain to acquire a blend of colour between the edge and middle section. Try to apply particularly lightly and add enough coats to achieve the coverage you wish to attain. At this time you should let the most recent coat harden off. As soon as the guitar is totally free of moisture commence with sanding for a second time.
The key here is to utilise a lighter measure of sandpaper every single time, essentially removing the marks from the gauge of sandpaper used previously. Remember to keep delicately sanding after that changing to a less heavy gauge unless you run out of sandpaper after which you can proceed to your buffer. From this point you should continue to keep buffing or hand polishing until you get completely fine with the finished look.